Brand new 🧨 Empire Guitars Walrus Audio SLO Texture Reverb *Free Shipping In USA* 😉

From Walrus Audio;

The Slö Multi Texture Reverb allows players
to create lush, modulated, sleepy and ambient soundscapes. Stocked with
three different algorithms specifically designed to invoke textures for
bringing dreams from your subconscious to reality.

The
toggle switch allows three different reverb modes, Dark (Lower Octave),
Rise (Ambient Swell) and Dream (Latching Pad), while secondary
functions on the switch change between different wave shapes for the
modulation on the reverb trail.

Combine deep modulation with long washy trails and experience, the Slö.

ALGORITHMIS:

DARK
– Add a lower octave to your reverb trail. Here you’ll create deep and
wide atmospheric sounds and channel nightmarish soundscapes. X knob sets
the level of a -1 octave signal that feeds the reverb.

RISE
– This is an auto-swell reverb for beautiful cinematic swells. Don’t
rush it. Let it breathe and gently wake up. X knob sets the amount of
time it takes the reverb to swell in after a note is played. Set lower
for shorter rise times and higher for longer rise times.

DREAM
– Here is a lush reverb with a latching pad function. Press the sustain
switch to latch signal. Experiment with the X knob to add vibrato over
the pad. Press sustain again and pad will decrescendo according to where
decay knob is set. X knob sets the depth of vibrato applied to the
reverb trail.

The Slö also features 3 different wave shapes accessible by holding down bypass while switching the algorithm toggle.

SINE – Smooth and even pitch up and down modulation.

WARP – Asymmetric pitch up modulation similar to a warped record.

SINK – Asymmetric pitch down modulation for sinking detune similar to a Bigsby.

MOMENTARY FUNCTIONS:

Bypass:
When the switch is in off position, press and hold to temporarily
activate the effect to add a moment of reverb texture. Releasing the
switch turns the effect off, and fades it out.

Sustain:
When pressed, the decay switch ramps up the reverb trail to maximum
creating long dreamy reverb trail and then ramps back down to the decay
knob setting when released. In the “Dream” algorithm, the sustain switch
is latching. Press it once to capture and sustain the current reverb
decay for extremely long pad-like sounds. Press it again to let the
reverb trail taper off, based on the position of the decay knob.

TRAILS MODE:

The
Slö can run in trails or no trails mode. In trails mode, when you turn
the pedal off, the reverb decay dies off naturally. In no trails mode,
the decay is abruptly cut off when you turn the pedal off. To toggle
between either mode, hold down the bypass switch for 1 second while
applying power to the pedal. Unplug power and repeat to toggle to the
other mode.